TRIM REDUCTION IN WIDE WEB FLEXO

Ask or answer questions related to the flexo prepress environment.

Moderator: Frank Burgos

TRIM REDUCTION IN WIDE WEB FLEXO

Postby prasadups » Sat Sep 29, 2012 2:07 am

hI,
now we use bearer bars after actual print size. and substrate used is little more on width after bearer bars. this is standard practice. but if we avoid these bearer marks we can reduce the film width with marginal difference. which will save lot of cost. but if we remove the bearer bars minus points are it works like support to print area and if we take it off we may face print issues and second thing is the job info is on bearer bars where to place it? Pl suggest on this.
prasadups
 
Posts: 3
Joined: Fri Sep 28, 2012 6:40 am

Return to Prepress

Who is online

Users browsing this forum: No registered users and 1 guest

cron