Seprate plates on the same cylinder.

Ask or answer questions related to the flexo prepress environment.

Moderator: Frank Burgos

Seprate plates on the same cylinder.

Postby wdustin1 » Fri Apr 15, 2016 1:31 pm

We run a lot of jobs that use the same die so we are playing with the idea of running 4 to 5 different jobs on the same plate and just running one lane each. The problem we ran into is the quantities on each job change with each run, so now we are trying to figure out how to take 5 1 across jobs and mount all of them on the same cylinder, they all use the same die and everything, we have never done anything like this before and was wondering if anybody else here has tried this and has any comments on it, good or bad? The only reason we need to change the single plates around is so we can group them by quantity instead of making new plates with a grouping on it every time, try to save some money this way. What do you guys do in these types of situations? We are actively trying to reduce setups and increase run times by running groups fyi
wdustin1
 
Posts: 17
Joined: Wed Oct 02, 2013 12:54 pm

Re: Seprate plates on the same cylinder.

Postby Fuzz » Mon Apr 18, 2016 1:06 pm

Totally doable if they are one color jobs. As long as there are marks on the plate to align with a scribe mark on the cylinder and your plate mounter can read a ruler to to get the distance across correct.
Fuzz
 
Posts: 259
Joined: Mon Jan 19, 2009 4:37 pm


Return to Prepress

Who is online

Users browsing this forum: No registered users and 1 guest

cron