create icc profile

Ask or answer questions related to the flexo prepress environment.

Moderator: Frank Burgos

create icc profile

Postby kamyabkavianiflexo » Fri Jul 14, 2017 3:07 am

Hi
What need for create icc profile for narrow web flexography?
Please advice or guidance me what do i do?
kamyabkavianiflexo
 
Posts: 6
Joined: Wed Jul 05, 2017 8:44 am

Re: create icc profile

Postby richflexo » Tue Jul 18, 2017 1:00 am

Hi there,

You'll need some software and some hardware. It will also depend on your plate making and rip equipment as well. But the hardware to read your charts is fairly standard. We use an Xrite i1i0 to read P2P charts that make our plate curves and then when those are printed we put on an IT8.4 chart that will make your ICC profile.

Software - curve 3 or 4 by chromix (makes curves for plates)
Hardware - Xrite i10 table (reads charts)
Resources - FIRST 5.0 (literature)

It's a science so get your production and pre press department on the same page before you start and build standards otherwise you'll be battling each other.

There is a lot more than that but read up on all the products and visit https://www.idealliance.org fore more info.
richflexo
 
Posts: 62
Joined: Fri Jun 01, 2012 3:01 pm

Re: create icc profile

Postby barb » Wed Jul 19, 2017 11:52 pm

Do you make plates in-house or do you have a supplier who does it for you?
barb
 
Posts: 27
Joined: Sun Sep 18, 2016 10:49 pm

Re: create icc profile

Postby kamyabkavianiflexo » Sun Jul 30, 2017 2:57 am

yes, we have supplier for make plates
kamyabkavianiflexo
 
Posts: 6
Joined: Wed Jul 05, 2017 8:44 am


Return to Prepress

Who is online

Users browsing this forum: No registered users and 1 guest

cron