KTI Turret Rewinder Issue

Ask or answer questions related to the flexo pressroom environment

Moderator: Frank Burgos

KTI Turret Rewinder Issue

Postby TexasMaintMan » Mon Apr 28, 2014 10:54 pm

On one of our turret rewinders running inline with a P7 Mark Andy keeps crashing. Today it crashed to where the buttons for tension would not work, the turret would not index, it would not release the air from the finish roll shaft. I've checked all the prox sensors. I've checked the e-stop circuits. I've checked the feed&bleed board, the dump valve, the knife sensor, the glue sensor. The Contactor 1 is not pulling in because CR5 is not happy. I do not know why CR5 is not happy!!!

Any one have knowledge or experience with KTI turret rewinders?
TexasMaintMan
 
Posts: 126
Joined: Fri Jul 27, 2012 12:18 pm
Location: Arlington, TX

Return to Pressroom

Who is online

Users browsing this forum: Bing [Bot] and 2 guests